Thermostat for fan in enclosure

The print is designed specifically for the Schneider Electric Thermostat ClimaSys CC

There are two versions of the print. One version with connect box for WAGO Connector and one version for 4 Connector Strip.

It is designed for 2x0.75mm2 flat wire (H03VVH2-F).

Necessary materials:

• Schneider Electric Thermostat ClimaSys CC (NSYCCOTHO)
• Set of 4 Connector Strip (~3A/ 4mm2) or WAGO 2-wire connector (221-412)
• 1 screw M4 x 10mm, M4 nut and washer

Note: 

The print is for electrical installation and is therefore designed with a focus on safety, but it is not approved by any authority and there is no declaration for compliance with any kind of technical standard. The use of this print is entirely at your own risk.