Christmas Tree Candy Dish v2

This tree has been printed with PETG and PLA without issue.  

• The tree does not need any supports.  
• The star will need supports.  I printed it in a few directions, I found the direction I have it was the easiest way to print the star.

The star will fit in the hole at the top of the tree.  Depending on your tolerances you may need a drop of superglue to hold it.

Print Settings

• Layer Height – 0.2mm (or 0.4mm with an .8mm nozzle)
• PETG or PLA
• Infill — 15% 
• Perimeters – 3
• Top Fill Pattern – Rectangular
• Bottom Fill Pattern – Rectangular