Floss Winder Handle

I printed the original winder and it works great, but I was not a huge fan of the hole for a handle. So I created this handle. The handle has two pieces, a base to keep it centered and a print-in-place handle that rotates freely.

You will need (1) M3x14 screw and M3 nut. (A longer screw will work too) 

If you have trouble tightening the screw the last few turns use the back end of a pen to press down on the center portion while tightening the screw.

This model does not need supports.

If you would like to support me: https://ko-fi.com/tinyboatproductions