Orc (light infantry)

I like fantasy miniatures, so I create my own orc.
I modeled, rigged and sculpted this orc in Blender.

Print instructions

This is my first rigged, printable miniature.
That's why the mesh is not perfect, but with fdm-printer it works fine and I hope with sla too!
The diameter of the base is 24mm.

My settings:
-I add a STL with support, that's how I print this figure(more support doesen't matter)!
-layer high: 0.1mm
-nozzle: 0.3mm
-cooling: 100% after the 2. layer

• print with "Brim" 20mm( there are some overhangs, so the nozzle could/will touch the print if the cooling isn`t enough.

I remove the support with a sharpe thin and heated knife.