Micro Airtag Clip

November '21 Update: As a designer it's important to test some of the stuff you think up. Anyway, I've been using the micro AirTag clip on my house keys since August '21 and it's been absolutely fine.

A minimalist clip for securing an Airtag to your things.

Takes only 20 minutes to print!

Print with 100% infill for maximum strength.

To use: insert AirTag towards the ring end first, then snap into place. Reverse this operation to remove.

If it's too tight, scale to 101% in your slicer and try again.

Print Settings

Printer Brand:

Monoprice

Printer:

Maker Select Plus

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

100

Filament: Fillamentum PLA Yellow