Calibet

This is a simple 20x20x20mm calibration test cube for your 3D printer with the Alphabet written on the axis.

To further calibrate your 3D printer print one out and you can then measure this models dimensions against the expected dimensions and from now on there are no more countless cubes all over the house. These calibration cubes can be used as alphabet cubes for children.

Once this is done you are able, if your 3D printer allows it, to adjust your Steps per mm in your printers firmware.

if:
e= expected dimension
o = observed dimension
s = current number of steps per mm

then:

(e/o) x s = your new number of steps per mm

Please leave a like if you like it. If you don't like it, write in the comments what the problem is and I will try to solve it.