Simple and quick print drawers/cabinet handle

Hi, everyone who has built printers has 8mm, loose, linear guides.

Great looking handle.

  Thanks to this project you can use them in a very useful way.

You can cut them (8mm rod) to any length and use them however you like.

You can even use it as a hanger.

It presents simple and quick to print screw handles for drawers, cabinets and everything that needs a fast, strong handle to open.

It can be used at home, in the workshop and anywhere you like.

The printout itself is very simple, it requires supports from the bottom, in a place where the supported area cannot be seen. It prints very quickly.
In addition, there is a support in the design that can be placed between two handles in the case of using a very long 8mm rod.

In fact, it could be anything that is 8mm in diameter :) And scrue on 

Screwing through the back into a 3mm hole (can be reamed)

Happy printing!