This bridge is designed as a direct put in part without destroying the original bridge of Bontempi GSW75/N child guitar.
It just snaps into the given gap and can be fixed using two small nails as you can see on the picture used as bolts.
The only modification needed to get it working is file bigger holes into the nut to hold 4 thick instead of 6 small strings.
Side note: The strings used are called Thundergut from Aquila.
Printer:
Tronxy X5S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
100%
Filament:
Noname PLA
Notes:
Using PLA might not be best choice. There is much force on this part and as you can guess in the picture after about half a year of use there is already a deformation of the block visible.
This does not break functionality therefore it is fine for me.
The author marked this model as their own original creation. Imported from Thingiverse.