My Magnetic DragonLock Clip

This is my take on a magnetic clip for the DragonLock 3D tile system. I printed it with my Elegoo Saturn Resin printer. Not sure if you can print with a FDM printer.

Their magnetic clips use two 3mm ball magnets. In my opinion, they are not strong enough. So I designed this. This uses one 3x6mm DIAMETRIC magnet. So the +/- poles run the length of the magnet and it can roll to what is needed. You can see that in the beginning of the video. https://youtu.be/NMk-tOi3Xn4 It repels at first, but the magnet rolls to the correct +/- and clips in. These are the same magnets used in the CATAN set on thingiverse.

The Diametric magnets can be found on Aliexpress or Amazon. Just make sure you buy 3x6mm.

Most importantly, make sure you trim and clean out the printed slots! These magnets need to be able to roll around to orient their poles, or it will not work!

Print Settings

Printer:

Elegoo Saturn

Rafts:

No

Supports:

No

Resolution:

.05

Infill:

100

Filament:

Elegoo Standard Resin Resin

GreyCustom Section==============

Category: Games