Cabinet & Drawer Pull + Knob

The slightly different pull for modern furniture.
There are different sizes for US and EU included. (knob follows)

For finishing I would recommend the method of HEN3DRIK to give the handles the right finish:
https://www.youtube.com/watch?v=MuhlMYTcByw

All credits for the finish go to HEN3DRIK.

I haven't had the time to do this myself, and if the method is too time consuming, you can of course use a metalic spray.
The picture is a render from fusion 360, but I think they look much better with a real metalic surface.
Photos of the prints will follow

The following variations are included:
-The Knob
- US 3" hole distance
- US 5" hole distance 
- EU 96 mm hole distance 
- EU 126 mm hole distance 
- EU 160 mm hole distance 
 

There are two mounting options, one version with 3mm holes for wood screws and one with 4mm for threaded inserts.

Material: PETG / PLA
Nozzle: 0,4
Layer height: 0,16 (works also with 0,2)
Infill: 20%
Print speed:  50mm/s
Print time: ~7h

Support is required (for an example see the picture)

Please note that this model requires post-processing to make it the artwork it was intended to be!

Update 06.11.2022:
Based on the constructive feedbak that the print layer lines are not quite hidden at the surface and support is required, I added a version for printing without support and rotated 90 degrees. This one does break the design element a bit, but is easier to print. So you can decide what suits you more.