Desktop Controller & Remote Holder -- REMIX

I needed a holder for my Xbox controller and some remotes (TV, soundbar, etc.). I found Jethro's model, but it was designed for an over-the-bed desk and required a screw to hold it in place. However, I really liked the controller holders that he designed, including the way they press-fit into the base.

I was OK hanging the holder off the side of a nightstand, but I did not want to screw it in place.

So, I remixed his holder to make it table-top stable (T-shaped). I also made one model with only one port for a controller. Refer to Jethro's model for the high & low controller holders. Photos show both the high and low controller holders.

Print settings:

• Ziro PLA Pro
• 6mm nozzle
• 0.3mm layer height
• 3 walls/perimeters
• 15% infill