This is a couple designs for an intel NUC5PPYH that I am using for Octoprint. This should fit other NUC5's in the same series, but can be made to fit others as well. There are two different designs amongst the files. One hangs the NUC vertically, the other is simply a base you place the NUC onto vertically.
Hanging NUC.
Sitting NUC.
All of the parts were printed without supports... if you use supports, make sure to remove support from the cleat section on the vertical stand. Those print fine with no support even though the slicer will complain about it.
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
.3mm
Infill:
20%
Filament: Sunlu PETG Black
Notes:
I like to print with PETG, but PLA and many other filaments should work here as well. For this, I also used a .6mm nozzle, but .4 will also work perfectly.
Post-Printing =============Post Processing: A little sandpaper down the cleat angles will help them slide more smoothly. Also, if necessary a bit of teflon lube works wonders (PETG only).
Designed in Fusion 360... all measurements taken with my trusty calipers.
Category: ComputerThe author marked this model as their own original creation. Imported from Thingiverse.