This model is a simple case designed for the DZS Elec 5V-30V Adjustable Delay Internal/External Trigger Relay Board (https://www.amazon.com/dp/B0721M35KH?psc=1&ref=ppx_yo2ov_dt_b_product_details)
This was designed to use the USB power (which will involve running + & - lines from the terminals near the USB port. There is room underneath the board for 22-24awg wire to run out of the back side of the case. The trigger wire must be run through the rear and wired under the board as well (although there may be room on the topside of the board as well). However, you can wire this as you please for whatever project you are using it on.
Happy building!
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
.3mm
Infill:
20%
Filament: Sunlu PETG Black
Notes:
Flip the lid onto the top to enable printing without supports.
Category: ElectronicsThe author marked this model as their own original creation. Imported from Thingiverse.