Kersey Fabrications Speed Test

This is a large speed test so that the printer can get up to speed for direction changes. Other tests I found on Thingiverse were too small to really test full-speed printing.

Included in this test are:

• Straightaways
• Curves
• Overhangs
• Embossed Text
• Debossed Text

To setup the print for proper speeds, use the Cura "ChangeAtZ" post processing plugin. I triggered on height 10, 20, 30, 40, 50, 60, 70, and 80mm. If you set the start speed at 40mm/s, you can increase the speed in 25% increments to get to the final speed, 125%, 150%, etc.

Print Settings

Printer Brand:

Creality

Printer:

Ender 5

Rafts:

No

Supports:

Yes

Resolution:

0.2mm

Infill:

10%

Filament: FilamentOne PLA Blue