Qidi I-Mate S filament spool holder

Description:

This filament roll holder is specially designed for the QIDI I-Mate S. It can be easily clipped to the housing and just as easily removed again.

It has a very low resistance compared to the original holder. When using 1kg (Ø200mm) spools, the cover still fits on the printer.
Smaller spools should also fit. With spools > Ø200mm it may be that the cover no longer fits on the printer. (I have only used 1kg (Ø200mm) spools so far and have not tried it yet. The spool is held in position by four clips that can be moved freely on the rollers, so spools of any width can be used. The maximum width is 98mm.

Needed parts:

1x side part right

1x side part left

2x roller

4x clip

4x standard 608 bearing

Print Settings:

Side parts:

Rafts: not needed

Supports: No

Resolution: 0.2 mm

Infill: 50%

Filament: PETG

Roller:

Rafts: not needed

Supports: No

Resolution: 0.2 mm

Infill: 20%

Filament: PETG

Clip:

Rafts: not needed

Supports: No

Resolution: 0.2 mm

Infill: 100%

Filament: PETG