Vase with patterns and shapes

NOTE: Due to overhang angles, you should not try to print this vase in vase mode.

This was my first attempt at making a vase in fusion360. Inspired by geometric patterns and shapes. I think it turned out quite beautiful in the end. Hope you like it!

Print instructions

Important for proper printing:

For the best results you should use .15mm layer height.
You must also:

Set top solid layers to 0
Set infill to 0%
Set number of perimeters to a minimum of 4

If you don't wanna do this yourself, just download the 3MF file, and change the filament and bed temperature to your desired values. In the 3MF file i have used standard 0.15mm quality + prusament PLA profiles on a MK3S.