INGCO 20V Tool - Workshop Holders / Brackets - V2

INGCO 20V (P20S) power tool bracket / mount, for holding/hanging your tools in your workshop space. VERSION 2.0

Improved version of this: https://www.printables.com/model/299468-ingco-20v-tool-workshop-holders-brackets 
Better fit, internal screw locations rather than external.

Can be mounted upside down (hanging) and slide the tools on to the holders. 

4 countersunk screw locations for screwing the mount to (or under) your shelf / bench.

Holders use the battery location, so the tools are mounted with the batteries removed.

Tested with Drill, Impact Driver, Impact Wrench, Jig Saw, Torch, and Multi Tool, so should work with most if not all available INGCO 20V P20S tools. Some tools are odd shapes relative to the battery location, so this mount may need to be attached to a wooden block or similar, so it can be mounted as you need it - such as the Reciprocating Saw.

For the prototype print shown I have just printed this with Sunlu Black PLA+, and eSun Gold PLA+, on my Bambu Labs X1C printer, printed on Textured PEI bed.
Supports are required just for the overhang where the tool slides in, very easy to remove and came off clean in my case.
15-25% infill should be totally fine, these were printed with 20%, 4 walls, 4 top/bottom layers - for a bit more strength.