Black PSU (MK3S+) replacement frame brace

Printing time under 6 hours when parameters below are used - achieving the proper stiffness of the bracket.

Printing parameters:
- 0,30mm DRAFT setup for Prusament PETG (PrusaSlicer)
- min. 40% gyroid infill
- min. 8mm Brim inside only

Additional parts to assembly:
- 2x screws M4x18 with low head (max. screw head height 2.7mm is recommended)
- 2x nut M4 with selflocking insert
- 2x washer for M3 screws

If you like / download please don't hesitate to push "like" button.