Easy and filament friendly Ikea Lack Enclosure (Ender, Prusa, Anycubic,...)

Easy and fast Ikea Lack Enclosure for your 3D Printer.
It fits 50cmx50cmx 0,2cm Acrylic glass on three sides
Backside is a 61cmx55cmx0.5-1.5cm woodplank
you can fit 2 120mm Fans in the backside when cutting out the holes (Advise: 1 Intake Down, 1 Outtake Up)

The Fan covers will be uploaded later on if you Interested

IMPORTANT: YOU NEED TO PRINT EVERY FILE TWICE SO YOU GOT 2 FEET OF EACH FILE. IN TOTAL YOU NEED 8 FEET.

THE ONES WITH THE BIG HOLES GO IN ON THE TOP
THE ONES WITH SMALL HOLES ON THE BOTTOM

You just need 2 Ikea Lack tables no matter which color.
and:
4x 12.5cm Hanger Bolt for wood
4x 6mm x 1cm head x 5.5cm long woodscrew
2x Hinges
1x Magnet closing Mechanism
1x Handle to open front door
3x Acrylic glass 50cm x 50cm x 0.2cm
1x Wood plank 61cm x 55cm x 0.5-1.5cm
22x Small wood screws

 Nails as much you need 

If questions are coming up feel free to ask

I will Upload finished pictures as son this build is done

Have fun!

Instructions:

1.Build 1Table

1. Take the 4 legs of the other table and put the caps with die big hole on the side where you would put the bolt. and screw the hangerbolt in (3.5cm ONLY!)
2. Screw in one screw into each side of the leg where you find the plastic plate

screw all 4 legs into the table

1. take the other 4 caps with the small hole and screw each one on the plate right above the legs with the 6mm screw

5.1. all Plastic plates should now reach into the air

Here you can put your Printer in so there´s no need to put it later on in

6.1. Fit in the two Acrylic glasses while putting them tables together

1. Put the other table on top of the caps and as in step 3 repeat it
   7.Now fit the back wood on and nail it in
2. But the hinges on the last Acrylic glass and then screw the hinges on the side of the table with the reaming wood screws
3. open the door and fit the magnetic closing mechanism in and also the Handle
   10.fit the Cable through the cable hole and off you go you´re done