DNL Kaabo Mantis 10 Mudguard [std/wide, front/back]

NON COMMERCIAL USE ONLY. If you intend to print this commercially, please contact me for licensing.

Longer mudguard/fender for Kaabo Mantis 10. Comes in variants:

• Standard (90 mm) | Wide (110 mm)
• Front | Back

Mudguards are longer than the original counterparts - especially the back mudguard is way longer, making it much more effective. Because of the length, the mudguards require extra support if you don't want them to snap. Also includes a damper spring protector part.

Hybrid metal support

There's a plastic support part that you can attach to the brake nuts, but I've been having issues with the plastic support not being strong enough, so I've also designed a separate hybrid metal support where one part (same for all variants) is laser cut from 2mm stainless steel.

You can purchase the entire mudguard (or just the screws, metal part and reflector) on my eshop: https://eshop.danol.cz/ (CZ only, but I might be able to ship abroad if you contact me)

Print config & hardware

Print config I've tested it with (I've included a 3mf file with the settings I'm using):

• PETG, 240 °C
• .6 mm nozzle, .3 mm layer height, .8 mm extrusion width
• 20% infill, 2 perimeters

You'll need:

• 4× M3x12 screw as a replacement for the short ones present with the default mudguard.
• 2× M5x16–20 screw + locking nut for attaching mudguard to the base
• 1× M5x12 screw + locking nut for attaching support to the mudguard
• If using the metal support, you'll need one extra M5×12 screw and nut.