Face Mask Clip for R95 H-filter

Face Mask Clip for R95 H-filter inspired by GarageLab project. Modified for using the rounded rubber.

The project contains a source file (* .3fd, Fusion 360) for your further modification or improvement.

You also need:
2x Rubber thread d=1.5mm, l=150mm
1x Filter paper w=200mm, l=240mm

The recommended paper folding is shown below.

Recommended accessories (PETG!)
https://www.prusaprinters.org/prints/30441-face-mask-nose-clip

GarageLab project
https://garage-lab.de/wp-content/uploads/garage-lab-duesseldorf-mund-nasenschutzmaske.pdf

Print instructions

Settings: 0.15 mm QUALITY
Infill pattern Gyroid, 25%
Filament: PETG

Depending on the settings of your printer, you will need to pass the rubber holes through a 2.0 mm drill bit