Actobotics X-Rail® End Cap
Available in stl (inches or mm). An endcap designed for Actobotics X-Rail®. Has two fastening methods. Can clamp…
2
11
0
97
updated
October 29, 2022
Description
PDFAvailable in stl (inches or mm).
An endcap designed for Actobotics X-Rail®. Has two fastening methods.
Can clamp directly to the X-Rail end (like a regular endcap). If there is not threads on the corner holes of the X-Rail one can also thread this 3D print, and use clamping force and use the whole thing as a X-Rail Nut and End Cap combo. Won't slide as well though.
Highly recommended to use higher infill if you seek to use the clamping force of the sides.
Print Settings
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.001" or 1/64"
Infill:
100%
Filament:
Any ABS
Notes:
At maximum resolution you will need is .001", but you can probably get away with 1/64" of resolution.
Support material should probably be made out of something that either dissolves, or is a lot thinner than the outside material, because you'll have to drill the side holes with #37 bit. Then you can thread with a tap, or just force thread it with the 6-32 bolt.Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.
