Vasecube - Calibration Cube/Nozzle Purger

Print this using vasemode

This is just a simple model I often use to purge my nozzle after a filamentchange. A filamentchange procedure is not always enough when going from dark to bright pigments and I dont bother to sit next to the printer and run the procedure. This is a set and forget print that just takes a handful of minutes to print, and I get a glimpse of the layer quality at the same time

Subscribe or follow me on:

Instagram: https://www.instagram.com/agepbiz/

YouTube: https://www.youtube.com/user/agepbiz

Twitter: https://www.twitter.com/agepbiz