Cabinet Cabinet-Knob

Description

Cabinet door knob … in the shape of a cabinet!

It is a two-piece print for simpler printing.

Multiple screw holes sizes are included (Smooth 2, 3, 4, 5 mm + Threaded M3, M4, M5)

Thread extra clearance is approx. 0.1 mm (Cabinet incut thread).

Shrink the pillar teeny-tiny bit if the fit is problematic.

Print Instructions

0.15 mm layer height is recommended for better detail on the tiny door knobs.

The cabinet can be printed with minimal infill.

Print flat on the back.

Supports in the backside hole are recommended.

The screw-in pillar should be printed as reinforced as necessary for intended use with screws.

Assembly

Screw in the pillar and You are done!

If the fit is not tight enough, use a bit of glue.