A remix of SSD's cleaned skull. The dice cup is a basic cylinder with some contouring to match the top of the skull, and a biorad warning sign debossed into the bottom. The zombie hunter blazon is engraved on the forehead.
26 hours to print on my Rep5 at 90% of full size, high resolution (.1mm layer height), 10% infill and 4 shells. Temperature at 220°C, print speed of 80 and travel speed of 120, which eliminated the worst of the hi-res stringiness common on the Rep5. The prebuilt print file for MakerBot uses these settings.
Be prepared to spend some time removing the supports, as they're pretty involved. I was a tad too aggressive and got a couple of spots of tearout, but no big deal (they're underneath). Thanks to SSD for the skull!
Category: DiceThe author marked this model as their own original creation. Imported from Thingiverse.