Adding a notch helper for VORON 2.4r2

Jig for adding a notch to the shaft of a VORON 2.4r2 Z ENDSTOP.
6
35
0
448
updated October 26, 2022

Description

PDF

Print details:

  • Material: PLA, PETG, ABS, or any filament you like. I use GNVTNTP Silk PLA Black.
  • layer height: 0.20mm
  • Supports: Not required
  • Infill: 15%

[English]

I made a jig for adding a notch on a 5x30mm stainless steel shaft with an inexpensive 6mm wide diamond file.

The following screws and nuts are used (after use they can be reused for VORON making).

M3x8 SHCS x 4

M3 HEX NUT x 4

Note 1: This is a jig for R2; the notch position seems to be different from R1. 

Note 2: If you use the Microswitch Z Endstop Board, the position of the notches may be different. Before adding a notch to the shaft, make sure that the notch is in the proper location.

[Japanese]

5x30mmのステンレス製シャフトに、安価な6mm幅ダイヤモンドやすりで切り欠きを加工するジグを作りました。
下記のネジとナットを使用します(使用後はVORON製作のために再利用できます)。
M3x8 SHCS x 4
M3 HEX NUT x 4

注意1:これはR2用のジグです。R1とは切り欠きの位置が異なるようです。

注意2:もしかしたらMicroswitch Z Endstop Boardを使う製作方法の場合、切り欠きの位置が違うかもしれません(未確認です)。シャフトを削る前に切り欠きの場所が適切になるかどうか確認してください。

 

Tags



Model origin

The author hasn't provided the model origin yet.

License