Original model here:
https://www.cgtrader.com/free-3d-print-models/art/sculptures/halloween-pumpkin-a4d78698-27f2-4622-a7be-5f92caf989cd
Make sure to go and give them some love!
Just a light up 3d pumpkin print, the pumpkin is in one piece while the battery and light holder is in the top of the pumpkin. Requires some simple (and maybe hard to reach soldering). There is a loop in the bottom of the pumpkin lid to create a positive contact point for the cr2032 by looping and soldering a wire through it to itself. I looped the ground wire from the front to the back and back to the front to create a ground contact point for the cr2032. it's not the best but i wanted to use as little space as possible and i'm fine with jank.
Printed using Anycubic Photon S, with anycubic white resin.
Painted outside with fluorescent orange and inside left white from resin print.
Lights used were:
Hyuduo 1W 5V LED Chip Bulb, Light Beads 200lm Brightness High Power Lamp Bead Light Source Chip with Aluminum Plate for Floodlight, Pack of 25(Yellow Light 588590NM)
The author hasn't provided the model origin yet.