Pokemon Kanto Badge Display

Design is with PLA, no supports required.  .2mm layer height at 10-15% infill.

The pokeball pieces should snap together, but if not you can glue them.  Once assembled, they just slide into main body.

The frame pieces snap into the main body, but you can glue them if you want a more permanent hold. 

The holes in the feet/stand are for magnets should you wish to use them, however I found that it wasn't necessary to keep the feet together. 

Note: the holes are to allow the pins through. The pin locations may not entirely match due to manufacturing variations, but I tried to allow enough room to account for that. 

Here's a link to where I got the badges should you like a reference (I am not associated with the etsy shop): https://www.etsy.com/listing/890351052/pokemon-kanto-region-league-badges-pin-8?ref=yr_purchases