Jeep WJ Grand Cherokee Front Bumper Retainer Clip 6505361AA

Front Bumper Retainer for 2000 WJ Jeep Grand Cherokee
1
35
0
579
updated October 25, 2022

Description

PDF

This is a front bumper retainer for my 2000 WJ Jeep Grand Cherokee Limited. I'm assuming it is the same for all 1999 - 2004 WJ Jeep Grand Cherokees, and you can't really mistake this for any other body fastener I have seen.

It is fully functional when printed in any tuff filament with resistance to road/petrol solvents like gasoline, diesel, tar, oil, etc.

The insert is intended to be printed at the angle I modeled it with for layer strength.

There is no better way to say this next part without making it obvious I tried to avoid it, so keep your mind out of the gutter

It will fit tight at first, so pop the tab in and out a few times to loosen the slot before installing the retainer in it's hole.

Print Settings

I printed this with Overture Easy Nylon, on a .4mm nozzle @ .6mm line width (for extra squish/layer adhesion), at 0.1mm layer height (again for squish/layer adhesion), with 100% infill.

Post Processing

To harden the parts I put them in my cold oven, set it to bake at 70c/180f for 2 hours, then left it in the oven to cool slowly for several more hours.

Overture's site specifies the 70c and 2 hours.

Tags



Model origin

The author hasn't provided the model origin yet.

License