A three piece, four colour coaster.
The large format 150mm / 6.25" diameter coaster is easy to use!
The blue spoke section was printed at 0.15mm to preserve the small radius.
The black background printed at 0.2mm with 0 bottom layers.
The two colour wheel section was printed at 0.25mm, mostly due to time restraints that day. I used silver silk PLA with three top layers of white.
10%-15% infill should be sufficient.
No supports
I used a Brim on the “Wheel” section, although it may not be needed.
The author hasn't provided the model origin yet.