Skeleton Kid Trick or Treat Container

About the model

Just in time for Halloween: the Skeleton Kid gets its own trick or treat container/basket/bucket/whatever-it's-called!

Print it in whatever colour you like: whether it's white to resemble a skull, orange to resemble a pumpkin, glow-in-the-dark or something completely wild.

This container can be used with or without the lid, and you can also add your own handle. (I had originally planned to include a printable handle, but wasn't confident that it would fit properly.)

How to print

For best results, print both models in the provided orientation, with supports enabled. Upwards of 10% infill should be fine.

If you want to use less support material, you can try printing the lid on its side (rotated 90 degrees). I've done this on my Ender-3 S1, so both model can print at once, but it does leave a rough edge.

If you like the model

Show your support by showing me your prints! Also check out my original Skeleton Kid model, also available for download.