This is a generic (and slightly overengineered) case to build a "Stick" Light with a LedStrip and a controller. It is build to match the wled Board from Serg74, but you can use other controllers, too.
The case has the following features:
Included are the following push-in pieces:
Everything can be printed without supports. You can use PLA for the case, but I suggest PETG for the rotating disc and its fastening plate. PETG allows a smoother movement.
What you need:
Assembly:
1. Screw the two disc halves (#1 + #2) together (3x M3x6mm)
2. If your led strip has an connector, thread the strip through the disc! (There is not enough space to fiddle the connector through, so if you have already your strip glued to the profile, you have to cut off the connector and wire directly).
3. Now glue the led strip to the alu triangle profile and screw the disc to it (3 "Spax" screws) using the three triangle shaped holes.
4. Insert the profile/disc item from inside through the hole in the base (#5).
5. Bring the touch sensor in place (if used), it will be fastened with the next step.
6. Mount the fastening plate (#6) over disc and touch sensor with 6 screws, let one side free. (6x M3x6mm).
7. Place the rotation stopper (#4) over the free side holes and mount it with another two screws (2x M3x6mm).
8. Check whether rotation works as it should.
9. Mount the pcb to the base plate (#6) (4 x M3*6mm).
10. Prepare the plugin pieces (#7) according your plugs/jacks and connect them to your pcb.
11. Slide the plugin pieces (#7) into the base (#5) .
12. If you want, fill the hollow walls with nuts or whatever you prefer.
13. Mount the baseplate (#6) to the case (#5) (4 x M3*6mm).
The author hasn't provided the model origin yet.