FLY-SHT36 Can Mount

This model is for mounting it directly at the back of a 36mm pancake motor. I have nowhere else to put it. I don't want it to be bulky and big so I designed my own. 
I added a cable tie mount to remove the strain on the connector itself from tool head movement.

100% Infill is just under 5 grams. That's PLA. 

Parts needed:
M3*15*5 Standoff (The one I used is from an FPV Drone frame)
M*10 or 15 Bolt (to hold the mount and canbus to the standoff.

--If using an NF sunrise or similar, you need a longer bolt that will protrude behind the mounting holes of the pancake motor because that is where you will screw the standoff.
-- Orientation is shown in one of the photos. Make sure you have good support settings.

PLASTIC SPACERS ARE RECOMMENDED between the bolt and the board.
PLASTIC SPACERS ARE RECOMMENDED between the bolt and the board.
PLASTIC SPACERS ARE RECOMMENDED between the bolt and the board.
PLASTIC SPACERS ARE RECOMMENDED between the bolt and the board.

Enjoy!