5015 Dual fan ducts for Modular BIQU H2 Mount for Ender 3.X

I like the concept of the Modular BIQU H2 Mount for Ender 3.X
But I wanted to use my existing base mounting plate.
The CR Toch was too close and the duct didn't fit.
The original design is slimmed down so it can fit BIQU H2 Ender 3 V2 mounting plate with CR Touch from Hetsie 
Included the fan mounting system because depending on your wishes you can increase/decrease thickness. (step and obj files)
printed with PETG (NovaMaker Lime Green)
Ducts 0.12 layer height (I have set 50% infill) Check your sliced model because if the layer height is too high you can end up with holes.

For the Star Trek fans…included 2 Borg themed fan covers for 50(15) blowers.