Oogie Boogie

Oogie Boogie Figure

Introduction

I created this figure mostly to practice sculpting in Blender. And since it turned out alright I thought I would share it on here. Since Oogie Boogie is basically a sack, the model can be printed easily enough. Speaking of it:

Printing Instructions

I printed the model you can see in the pictures on a Prusa MK3S+ in PLA without any issues. Layer height is 0.15mm with an infill setting of 10%. 

I chose the orientation on the bed in a way that the model is only supported on the back and on the bottom side with supports on the build plate only. I placed the seam into the seam on the side of the model so that it won't be noticeable.

Final Words

If you have questions, remarks, suggestions, I would be happy to hear from you. 

By the way, you also can support me and my work with a coffee at

https://ko-fi.com/agentmess