PHONE HOLDER

INTRODUCTION:
THIS IDEA WAS DEVELOPED THINKING OF PEOPLE WHO ARE UNDER PREVENTIVE AND MANDATORY SOCIAL ISOLATION (ACCORDING TO ITS NAME IN ARGENTINA) AND WHO HAVE A 3D PRINTER AT HOME.
ORIGIN OF THE IDEA:
THE IDEA EMERGED WHEN A MEMBER OF OUR CLUB HAD DIFFICULTIES TO HOLD THE PHONE WHILE PERFORMING OTHER WORKS ON A TABLE.
INFORMATION SEARCH:
FIRST THE PROJECT MEMBERS MADE A SKETCH, IN WHICH THE DESIGN WAS EXPOSED.
THEN IT WAS DEBATED WHICH OF THE DESIGNS WAS MORE COMFORTABLE.
DESIGN:
THE DESIGNS WERE MADE IN FUSION 360 AND THE INTERESTING DETAILS WERE GRANTED AS: A COMFORTABLE POSITION TO AVOID NECK PAIN OR A HOLE TO PLACE THE CHARGING CABLE OF THE DEVICE

Print instructions

3D PRINTING:
IT IS RECOMMENDED TO USE THE FOLLOWING PARAMETERS (IT IS IMPORTANT TO CLARIFY THAT THEY MAY VARY ACCORDING TO THE BRAND AND MODEL OF THE PRINTER):
LAYER RESOLUTION: 0.2mm
WALL THICKNESS: 1.2mm
FILLING: 50%
PRINT SPEED: 70mm / seg
NOZZLE TEMPERATURE: 210 ° C
HEATED BED TEMPERATURE: 70 ° C

IT IS ALSO NECESSARY THAT THE FILAMENT MANUFACTURER RECOMMENDS BETWEEN 60 ° C AND 80 ° C OF HOT BED AND BETWEEN 180 ° C AND 220 ° C OF TEMPERATURE IN THE NOZZLE. ALSO THE IMPLEMENTED PRINTER WAS A TRIMAKER COSMOS ll (MADE IN ARGENTINA)