Tablet Mount For Office Desk

This thing was designed so I could place my tablet in it and still use it at my desk. I have done a test print and fount that the upper supports were only one wall thick so I enlarged it to 2 or 3 walls thick.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

40

Filament: Maths Pla+ siver

Notes:

in the slicer I increased the bottom layer thickness and increased the wall thickness by 2 and set the infill to 40% all to make the part strong.

Installation:

I plan on using the 4 screw holes to screw it directly to my desk, I have not done that yet. The pilot holes are slightly under sized but that is ok it is much better than slightly too large.