FILTER PLUG

INTRODUCTION: THIS IDEA WAS DEVELOPED THINKING ABOUT PEOPLE WHO ARE UNDER PREVENTIVE AND MANDATORY SOCIAL ISOLATION (ACCORDING TO THEIR NAME IN ARGENTINA) AND WHO HAVE A 3D PRINTER AT HOME.

ORIGIN OF THE IDEA: THIS IDEA WAS BORN DUE TO THE CONCERN OF A PARTNER, WHO CAN NEVER KEEP THE TUBE CLEAN BECAUSE THE FILTER IS TOO LARGE.
INFORMATION SEARCH: BEFORE WE CAN BEGIN THIS IDEA, WE MUST INVESTIGATE THE FILTER MEASURES AND THE EXISTING INCLINATION ANGLE FOR IT WORK PERFECTLY.
DESING: IN ORDER TO BE ABLE TO CREATE THE DESIGN, A VIDEO CALL WAS MADE IN WHICH EACH MEMBER OF THE SCIENCE CLUB DESIGNED A SKETCH OF THE IDEA TO SEE WHICH WAS THE MOST CONVENIENT AND THE MOST APPROPRIATE. THE DESIGNS WERE MADE IN FUSION 360.
IT MUST BE HIGHLIGHTED THAT THE MOST USED MEASURE IN ARGENTINA IS 2´´ (TWO INCHES). SO IF IT CHANGES ACCORDING TO THE COUNTRY, IT IS RECOMMENDED THAT BEFORE CHANGING THE ENTIRE DESIGN, YOU SHOULD CHANGE THE SCALE OF THE DESING.

Print instructions

3D PRINTING: IT IS RECOMMENDED TO USE THE FOLLOWING PARAMETERS (IT IS IMPORTANT TO CLARIFY THAT THEY MAY VARY ACCORDING TO THE BRAND AND MODEL OF THE PRINTER):
LAYER RESOLUTION: 0.2mm
WALL THICKNESS: 1.2mm
FILLING: 50%
PRINT SPEED: 70mm/seg
NOZZLE TEMPERATURE: 210 ° C
HEATED BED TEMPERATURE: 70 ° C
IT IS ALSO NECESSARY THAT THE FILAMENT MANUFACTURER RECOMMENDS BETWEEN 60 ° C AND 80 ° C OF HOT BED AND BETWEEN 180 ° C AND 220 ° C OF TEMPERATURE IN THE NOZZLE. ALSO THE IMPLEMENTED PRINTER WAS A TRIMAKER COSMOS ll (MADE IN ARGENTINA)