BambuLab X1, Lift the lid more easily

This model is heavily inspired by the lift-kit of Zakm0n ( https://www.printables.com/model/287928-bambu-x1-lid-lift-kit ).

With the AMS on top of the X1, placing and removing only two spacers is more easy.

The lid will be at an angle of 3.24 degrees, low enough to keep the AMS sturdy in place and high enough to create an opening of 2 cm at the front to dissipate the build up heat.

Update: a version 3 is added. Support in the inner corner is hard to clean in v2. It is important that the corner is clean for a good fit. In V3 that corner is set free of support by cutting out a triangle. Not important for the strength.  

Happy venting :)

PS. lifting the top, will give more fumes.

Warning: Placing and using the pieces makes the glass more vulnerable.