Mounts are positioned for printing, no supports needed.
Examples in pictures are printed using PLA Plus at .28mm layer height and 15% infill.
I used 3 mounts total to hold the keyboard. They are designed to fit into the open space on the back of the Oxygen 49 keyboard and hold it up from the middle instead of the keyboard resting on the bottom ledge of the mount. The mounts are also angled to place more pressure on the rest points and limit forward tilt to reduce chances of the keyboard falling off.
These are very specific to the M-Audio Oxygen49 keyboard and may not fit other brands or models.
These mounts are intended for storage only and not meant to mount a keyboard while being played.
The author marked this model as their own original creation.