Soapdish Pro

A tool that may save life. Say howdy to a soapdish that is extreme in every way. Great performance, configurable, it was created to let a wide range of makers to push the limits of what is possible while keeping their hands clean.

The Soapdish Pro consists of three parts:

• A high tech drainer that you can modify as you wish using the PrusaSlicer software. Two templates (soapdishproplatevirgin.stl, prusaslicermodifiershape.stl) are attached to facilitate this task.

• A bowl with raised edges aligned to the drip tray for better grasp of your soap. You can print this bowl in different colors with your favorite filament but also cast it in plaster or concrete thanks to a printable mold.

• Feet raise the bowl to keep it always clean from any dirty water splash.

The Soapdish Pro is a daily use utensil now made available to you.

PS: since, at this time, prusaprinters.org does not accept FreeCAD file extension .FCStd , you'll find the source file at thingiverse.com

Print instructions

All parts should be easy to print without any support material. It is recommended to print the default drainer at 0.15 mm height with a nozzle of diameter 0.4mm.