Spider's Web ~ A 3D Printer stress test

A Halloween-themed torture test for your 3D printer! #E3DSpider
56m
1× print file
0.20 mm
0.40 mm
8.00 g
3,832
20 k
857
76 k
updated March 23, 2023

Makes

Comments

Turns out well with fuzzy skin enabled, I would love to print that at 200% scale

I have to tweak some settings…

Very nice design, printed in 34 minutes. The spider web broke when I took it out of bed, I think I should have been more careful.

Wow! My flying bear 5 did it! The printer if full stock, with no upgrades. I printed PLA GF, nozzle - 0.4, layer - 0.2. Some problems of the layers are most likely due to poor winding of the filament coil - sometimes it wedges. I also see problems with the cooling of the rear of the model. And it looks like it's worth increasing the retraction a bit. As it is, it's pretty damn good for him!

cute test, thank you! Slicer - orca 2.2.0, material - anycubic PLA+

Was impressed my printer succeeded! Awesome!

Printed good, except for the fact that the spider web breaks easily. (Probably my settings, though)

Printed okay, got a lot more tuning to do.

I am glade my ender 3 is still a beast.
0.2 mm layer
no supports
1 hr print