I modified it slightly, before printing. I dropped it down below the print area in the slicer, so it only printed 6 layers thick with .2mm layers. I also blew them up to print larger...about 6in across at the widest. (edited)
@Mordiev as thin as they are (3 layers), the light does show through just a bit. I also used dual tone filament ( https://www.amazon.com/gp/product/B0C37GD865/) and printed with concentric layers (attached a picture).
@BenSetliff oh! That makes sense. Good looking effect.
Absolutely beautiful model!
I would scale the models to 125% to get the full detail out of them.
Printed as part of an activity board. Printed well and was easy to paint. Thanks for this awesome model!
I like it. For these two PVB prints, I used an XY size compensation (aka "horizontal expansion") of 1mm to make the antennae less fragile.
https://www.printables.com/model/163710-glass-butterfly
https://www.printables.com/model/156332-cinderellas-glass-slipper (edited)
@JeremyReeder Good idea to stretch it on the X like that. I like the clear look.