This LED Bracket holds a 12mm strip flat on the wall.
I used 3,5 x 16mm SPAX PH2 screws to hold it in place on a wodden ceiling.
Evenb with PLA you can screw them pretty tight to the wall.
Printer:
Anycubic Kobra
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0,2mm
Infill:
25% Gyroid
Filament:
Anycubic PLAGrey
Notes:
Bridging should be turned on.
I used 8 Lines of Brim for the Adhesion.
I printed it with 50mm/s and sliced it with cura.
The author marked this model as their own original creation. Imported from Thingiverse.