Ender-3 V2 Front Electronics Housing | Remix

New updated model here!

----

This is a remix from user @Pedrolamas

What I noticed right away was that the back screws used to secure the top are in an akward position.
They either didn't line up, or were barely reachable. I ended up just using the front screws and leaving the back screws out.

What I changed:

• Changed the back screw design to a slide system. There are no more screws in the back.
• Added another fan cutout to the right side for the Raspberry Pi.
• Turned the position for the Raspberry Pi 90 degrees.
• Made a cutout on the left and right top guides, to accommodate for the fan so the top can sit flush.
• Made a cutout for the Z-axsis and Z end switch wires to go to the motherboard.
• Reinforced the back for more rigidity.
• Reinforced the front for more rigidity.
• Moved the fan position to accommodate for the micro usb port on the motherboard.

Printing:

Make sure that the top pieces are turned around 180 degrees.

• Resolution: 0.2
• Infill: 20%
• Generate Support: checked
• Support Structure: Tree
• Support Overhang Angle: 50.0

Print time aprox. 28.5 hours