Black and Decker EU Battery Charger and Holder (v1)

Click here for Version 2 instead

It has two parts.  

Main Body

• You can “push” the loader with its wire in the whole - push until flush with the other side.
•  
• Then tuck the wire in the small gutter - chose any side you wish
• 
• Once the holder is in place, you can “slide” from the top (the battery will rest on top of the holder)

Wall Mount

• Screw on a wall, the row with 2 holes goes “on top”.  
• Look at the screw head indents for direction.  
• 
• The lip goes at the botom, pointing out from the wall
• 

Slide your battery

• You can slide your battery and push until it fits in the charger.
• 
• If place higher than eyesight, you will see (from the underneath part) the light indicators from the charger

Print format?

I printed on my amazing new Bambu X1 which got it out the the box right.

This being said, 

• I printed in 0.24 layer height (PLA)
• 8 walls!!!  Batteries are very heavy.  That's a bit load on that small holder.
• Infill 50%
• It worked without problem with no support on my side (the bridges are all straight)

You might have to do with horizontal expansion (see below)

Enjoy!