Catrike Display mount for Eggrider V2 or SW102 for BBSHD or BBS02

This is a mount I designed to place the Eggrider V2 display directly above the left (or right) handle of my Catrike Dumont. It goes into the end of a 7/8" tube and should work for other trikes that use 7/8' handles. I wanted my display to be within easy reach so that I wouldn't have to take my hand off the handle while pressing buttons on the Eggrider. It's far from perfect but it does the job and looks halfway decent I think.

I printed the main piece on its side with the largest flat surface facing down (with supports). The other two lower pieces were printed vertically with no supports needs

This uses M5 hardware:

1 - Nut

1 - 25mm Bolt

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

200

Infill:

100

Filament: Amazon PETG Black