Do you often lose your poppy? Or worse yet, do you get poked by the end of the pin a lot? This poppy clip is designed…
1
18
0
172
updated October 19, 2022

Description

PDF

Do you often lose your poppy? Or worse yet, do you get poked by the end of the pin a lot? This poppy clip is designed to prevent both of those problems. The spacing on the spring is designed to hold the clip onto light jackets. You could adapt it for thinner material. Use a small pair of pliers to push the pin into the hole. If it is too snug then just heat up the pin slightly with a match to get it warm enough to push into the plastic hole.

Print Settings

Rafts:

No

Supports:

No

Resolution:

.15

Infill:

100

Filament: Spool 3D PLA Black


Notes:

Print speed was 30 mm/s

Category: Accessories

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License