BLTouch gauge

Simple tool to adjust BLtouch Body to heatbed spacing

8.3mm height

Pin goes in U groove and small dimple on oposite side is for a finger.

Home your printer, release the screw on BLTouch mount, slide this gauge under the BLTouch body, make it sit flush with top surface and tighten the screw. 

Reworked a model based on instructions from www

Tested with Genuine Antclabs BLTouch v3.1 and ender 3 pro with Blockhead/bullseye base  

First layer 0.2 others 0.1 layer height so you have exact 8.3 height