The z flip phones have the charging receiver in the middle of the bottom half in order to allow charging while folded and perhaps because it could not be done in the hinge. Because the charging pad was too high or the phone was too low, I decided to lower the charging pad, so the the phone wouldn't be too high in portrait position. This meant that there was not enough room underneath for the wire to pass through, so I had to cut a hole at the top to give power to the charging pad. On the bright side, when it's not being used, the ‘Anker’ branding is right side up this way though!
It's a little rough, as I am new to this, but I tested it and it seems to work fine. I may want to make an adjustment to make landscape work a little more easily, including making the extra supporting wall on the left a little thicker, but for now, it definitely gets the job done!
If there's some demand, I can whip out a version without the support for landscape on the left, thus making it a little smaller (<450mm diff)
The author remixed this model.